Result Codes - AT&T DataPort PCX Modem User Manual

Result Codes

Result codes are informational messages sent from the
DataPort PCX modem and displayed on your monitor. They can
inform you of the status of a call (RING, NO ANSWER), whether
or not a command is valid (OK, ERROR), or at what rate the
modem has connected (CONNECT 14400). Refer to the Q n , V n ,
and X n commands in Appendix B for more information.
DataPort PCX Result Codes
Table E-1.
Numbers Word
(ATV0) (ATV1)
0 OK
1 CONNECT
2 RING
3 NO CARRIER
4 ERROR
5 CONNECT 1200
6 NO DIALTONE
7 BUSY
8 NO ANSWER
9 CONNECT 0600
10 CONNECT 2400
1
For ATX0, result code 1 or CONNECT is displayed instead.
2
For ATX0 and X1, result code 3 or NO CARRIER is displayed instead.
3
For ATX0, X1, and X2, result code 3 or NO CARRIER is displayed instead.
4
Refers to DTE rate or DCE rate depending on setting of ATW n .
1
2
3
1
1, 4
E
(1 of 2)
Description
Command executed
Modem connected to line
Modem receiving a ring voltage
from the dial line
Modem lost or does not detect
carrier signal, or does not detect
answer tone
Invalid command
Connection at 1200 bps
No dial tone detected
Busy or trunk busy signal detected
No ''quiet" answer @
DTE connection at 600 bps
Connection at 2400 bps
Issue 2 July 1995
E-1