AT&T DataPort PCX Modem User Manual page 64

Communications and Fax Software Settings
Guidelines for Specific Software
The AT&T Paradyne BBS (813-532-5254) has the latest
updates, special settings, and initialization strings for some
popular communications and fax packages. If you cannot get
your software to work using the guidelines in this appendix,
install QuickLink II Fax
check the BBS for further information.
If your configuration requires settings to your software or your
modem that are not mentioned here or on the BBS, please let us
know by writing to Technical Publications, telephoning Technical
Support, or uploading information to the BBS.
QuickLink II Fax is shipped already configured for DataPort PCX
modems:
G
The init string is AT&FE1V1&C1&D2S0=0S7=90
G
Baud Rate is 19,200 bps
G
Hardware Flow Control is selected
G
Autobaud is Off
Add the +H11 command to the initialization string to enable RPI.
If you add no other commands, your initialization string should
look like this:
AT&FE1V1&C1&D2S0=0S7=90+H11
If you do not intend to receive a fax from another user, then
change Answer Mode to Data Only.
NOTE:
Change the initialization string and Answer Mode using
the Modem Setup window of QuickLink II Fax.
C-4
Issue 2
t
temporarily so that you can use it to
July 1995