Government Requirements And Equipment Return - AT&T DataPort PCX Modem User Manual

Important Regulatory Information
5. General purpose cables are provided with this product. Special cables,
which may be required by the regulatory inspection authority for the
installation site, are the responsibility of the customer.
6. When installed in the final configuration, the product must comply with the
applicable Safety Standards and regulatory requirements of the country in
which it is installed. If necessary, consult with the appropriate regulatory
agencies and inspection authorities to ensure compliance.
7. A rare phenomenon can create a voltage potential between the earth
grounds of two or more buildings. If products installed in separate buildings
are interconnected, the voltage potential may cause a hazardous
condition. Consult a qualified electrical consultant to determine whether or
not this phenomenon exists and, if necessary, implement corrective action
prior to interconnecting the products.
In addition, if the equipment is to be used with telecommunications circuits, take
the following precautions:
– Never install telephone wiring during a lightning storm.
– Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
– Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
– Use caution when installing or modifying telephone lines.
– Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be a remote risk of electric shock from
lightning.
– Do not use the telephone to report a gas leak in the vicinity of the leak.

Government Requirements and Equipment Return

Certain governments require that instructions pertaining to modem connection to
the public switched telephone network be included in the installation and
operation manual. Specific instructions are listed in the following sections.
United States
Notice to Users of the Public Switched Telephone Network
1. This equipment complies with Part 68 of the FCC rules. On the equipment is
a label that contains, among other information, the FCC registration number
and ringer equivalence number (REN) for this equipment. If requested, this
information must be provided to the telephone company.
2. The Universal Service Order Code (USOC) associated with the services the
equipment is to be connected is RJ11C.
Issue 2 July 1995
D