Related Manuals for AT&T RM 5400
Summary of Contents for AT&T RM 5400
- Page 1 Equipment information and assembly guide for replacing the POTS modem with RM 5400 Modem © 2013 AT&T Intellectual Property. All rights reserved. AT&T, Globe logo and other marks are trademarks of AT&T Intellectual Property.
- Page 2 CAS device at your 2 Antennas location back Power supply Unit for the RM 5400 Modem Power Plug Tips for various country electrical connectivity An RJ45 25 foot cable An empty box, and pre-paid mailing label for shipping old RJ45 Cable Labelled ISE 10301-25.
- Page 3 Understanding your RM 5400 Modem Front View of RM 5400 Rear View of RM 5400 © 2013 AT&T Intellectual Property. All rights reserved. AT&T, Globe logo and other marks are trademarks of AT&T Intellectual Property.
- Page 4 Understanding your RM 5400 Modem Front Panel of RM 5400 modem Rear Panel of RM 5400 © 2013 AT&T Intellectual Property. All rights reserved. AT&T, Globe logo and other marks are trademarks of AT&T Intellectual Property.
- Page 5 Disconnect POTS Modem (if it exists at your location) Disconnect the power cable from the Modem Disconnect the phone line from the back of the modem Disconnect the phone line from the wall jack Disconnect the Modem cable from the back of the modem Disconnect the Modem cable from the console port of the router Package all the above equipment in the supplied box.
- Page 6 Disconnect Call Director (if it exists at your location) REAR VIEW Disconnect the power cable from the Call Director Disconnect the console cables from the Call Director. Might be up to 4 Disconnect the console cables from the equipment Disconnect the Modem cable from the Call Director. The other end is connected to the modem.
- Page 7 Wait for a couple of minutes till front panel lights are stabilized Setup the RM 5400 Modem where you can get at least 2 Signal Strength lights are lit Move around up to 25 feet from the Router if necessary to get 2 signals.
- Page 8 Step 3: Connect RM 5400 Serial Port to the Router Console Port Router Note that the back of the router may look differently than this. Locate the serial port on the device and connect. RJ45 Cable Labelled ISE 10301-25 RM 5400 Connect to more device console ports if needed as shown Use ISE 10302-25 cables to connect to AT&T VPN managed CSU-Probes...