Important Safety Instructions - IDTECK SR10 User Manual

1. Important Safety Instructions

When using the 13.56MHz [MIFARE] Contactless Smart Card Reader (SR10) / 13.56MHz
Contactless Universal Smart Card Reader (SR10U) / Fingerprint Stored Smart Card ID Only
Reader (SR10B), basic safety precautions should always be followed to reduce the risk of fire, electrical
shock, and injury to persons.
In addition, the following should also be followed:
1. Fully read and understand all instructions and follow them completely.
2. Follow all warnings and instructions marked on the product.
3. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning. If necessary, use mild soap.
4. Do not use this product near water.
5. Only operate this product using the type of power source indicated. If you are not sure of the type
of power supplied to your installation site, consult your dealer of local power company.
6. Never insert objects of any kind into the product or through the cabinet slots as they may touch
voltage points and/or short circuit parts possibly resulting in fire or electric shock.
Never spill liquid of any kind on the product.
7. Never disassemble this product by yourself; take the unit to a qualified service center whenever
service or repair is required. Opening or removing the covers may expose you to dangerous
voltages or other risks. Also, incorrect reassembly can cause electric shock when the unit is
subsequently used.
8. Unplug this product from the Direct Current (DC) power source and refer to qualified service
personnel under these conditions:
When the power supply cord or plug is damaged or frayed.
If liquid has been spilled on the product.
If the product does not operate normally after following the operating instructions in this
manual.
Adjust only those controls that are covered by the operating instructions in this manual.
Improper adjustment of other controls that are not covered by this manual may damage
the unit and will often require extensive work by a qualified technician to restore normal
operation.
If the product exhibits a distinct change in performance.
3