Show Ip Settings; Show Ip Network <Network_Name> Settings; Output Counters - 3Com OfficeConnect Remote 812 Cli User's Manual

B-42 A B: CLI COMMAND DESCRIPTION
PPENDIX

show ip settings

show ip network
<network_name>
settings
Forwarded Packets - number of packets forwarded


Bad Protocol - number of packets received with bad protocol


Discarded - number of packets discarded


Successfully Delivered - number of packets successfully received

OUTPUT COUNTERS

Total Output Datagrams - sum of datagrams transmitted


Discarded - number of datagrams discarded


Bad Routes - number of datagrams with a bad route


Fragments Needing Reassembly - # of fragmented datagrams


Datagrams Successfully Reassembled - # of broken datagrams


successfully reassembled
Reassembly Failures - # of broken datagrams unsuccessfully reassembled


Datagrams Successfully Fragmented - datagrams successfully broken


before transmission
Fragmentation Failures - failed datagram fragmentations before


transmission
Total Fragments - sum of fragments transmitted


Displays system wide IP information.
IP Dynamic Address Pool Begin - start of IP address range


IP Dynamic Address Pool Size - size of IP address range


IP System Host Address - IP address of the system


IP Forwarding - ENABLE or DISABLE forwarding of IP packets


Displays parameter settings for the specified IP network. See the set ip network
command on page 29 for additional details.
Interface - interface this IP network runs on


Network Address - network address of this IP network


Frame Type - frame type used by the interface


Status - ENABLED, ACTIVE, INACTIVE, DISABLED


Reconfigure Needed - This is TRUE or FALSE.


Mask - subnet mask used by this IP network


Station - station address of this IP network


Broadcast Algorithm - broadcast algorithm used for this network


Max Reassembly Size - maximum packet size allowed to be reassembled


from fragments
IP Routing Protocol - routing protocol used


IP RIP Routing Policies - routing policies used by RIP