List Facilities; List Filters; List Files; List Interfaces - 3Com OfficeConnect Remote 812 Cli User's Manual

list facilities

list filters

list files

list interfaces

list ip addresses

list ip arp

list ip interface_block

Displays the system facilities (processes) currently running, plus the default log
level. The log level is the severity of error that facility will produce syslog entries
for. You can change the log level using the set facility loglevel command.
Displays all the filter names in the filter table, which you previously defined using
the add filter command. You can remove filters using delete filter. The command
lists the filter file name, the status of the filter, and the protocols the file applies to.
For example:
Filter Name Status
easyfilter.fil NORMAL
Displays the files currently stored in the FLASH file system. You can remove files
using delete file, but you can add them using TFTP only.
Displays the installed interfaces, along with their operational status, administration
status, and interface index. If an interface is down, you can use enable interface to
try to bring it up. The command lists:
Index - number used to identify the interfaces position in the table


Name - interface name: eth:1, DA:1 or loopback


Oper Status - current, operating status of interface; UP or DOWN


Admin Status - administrative status you designated interface to be, up or


down. If it doesn't match Oper Status, a problem exists with the interface.
Displays the IP address for each interface. It lists:
Address - IP address of the interface


Bcast Algo - broadcast algorithm used


Reassembly Max Size - maximum allowable size of packet that can be


reassembled from a fragmented packet
Interface - interface this IP address uses to connect to the system


Displays the contents of the ARP cache. It lists:
IP Address - IP address for this entry


Phys Address - MAC address that the IP address maps to


Type - interface type: Ethernet or Token Ring


If Name - eth:1, DA:1 or loopback


Displays the IP addresses associated with each system interface. If the interface has
a point-to-point connection, then the neighbor field contains the address of the
remote system. This command lists:
Address - IP address of the interface


Neighbor - IP address of the remote system


Status - status of the connection; ENABLED or DISABLED


Interface - eth:1, DA:1 or loopback


Protocols
IP IP-RIP
CLI Commands B-17