Set Facility <Facility_Name> Loglevel [Level; Set Ilmi Vpi <Number> Vci <Number; Set Interface <Interface_Name - 3Com OfficeConnect Remote 812 Cli User's Manual

set facility
<facility_name>
loglevel [level]
set ilmi vpi <number>
vci <number>
set interface
<interface_name>
number_retries <number>


timeout <seconds>


Sets the global parameters for DNS; both the local DNS hosts (list DNS host) and
the remote DNS servers (list DNS servers).
Parameters Description
cache_size Enter the size of the cache. The valid range is from 20-500.
number_retries Number of times the resolve name request will be sent to each Name Server
if the server fails to respond to a request before the timeout period. Default
is 1, valid range is 1-5.
timeout Number of seconds to wait before deciding a request to a Name Server has
timed out. Minimum interval and default is 5 seconds, maximum interval is
120 seconds .
Sets the severity reporting level for a facility. The hosts that will receive the error
log entries are defined using add syslog loglevel. Use list facilities to see what the
current loglevel is for each facility. The levels:
CRITICAL - a serious system error, which may effect system integrity


UNUSUAL - an abnormal event, which the system should recover from


COMMON - a regularly occurring event that is not frequent


VERBOSE - a regular periodic event, e.g. a routing update message


DEBUG - for debugging purposes only


This allows modification of the Virtual Path or Channel ID that will be used for
exchanging ILMI (Integrated Local Management Interface) messages.
Parameters Description
vpi The virtual path identifier for the ILMI.
vci The virtual channel identifier for the ILMI.
filter_access [ON | OFF]


input_filter <filter_name>


output_filter <filter_name>


Sets filter parameters for the specified protocol on the specified interface. You can
see the available filter files using list filters, view the contents of a filter file using
show filter, and add filter files to FLASH memory using TFTP.
Parameters Description
<interface_name> Designation of interface you are setting parameters for. Limit of 32
characters.
filter_access ON causes filters specified for an interface with a set interface command,
to override filters specified with a set user command, when the filters are
of the same type.
input_filter Name of filter file you wish to be applied to the input stream coming in on
the specified interface. Limit: 20 characters.
output_filter Name of the filter file you wish to be applied to the output stream leaving
the specified interface. Limit: 20 characters.
CLI Commands B-25