Top Vent Or Side Vent Configuration; Converting The Fireplace To Side Vent Configuration - Travis Industries 864 ST Installation Manual

Finalizing the Installation

Top Vent or Side Vent Configuration

This appliance is shipped in the top vent configuration. To change to the side vent configuration,
follow the directions below.
NOTE: the vent configuration affects several aspects of installation (framing, maximum vent rise,
maximum vent run). When reviewing the installation requirements make sure to pay attention to the
type of configuration being used.
Converting the
Fireplace to
Side Vent
Configuration
© Travis Industries
Remove the back plate on
the fireplace.
NOTE: Use a magnetic-tipped
nutdriver on these screws -
take care to prevent the
screws from falling into the
fireplace.
Remove the flue assembly.
Tuck the two 24" pieces of insulation
into the area between the exhaust
manifold and fireplace can.
WARNING: Failure to properly
place the insulation will void the
warranty and create a safety
hazard.
(for qualified installers only)
4071126
9
100-01195_000