Top Vent or Rear Vent Configuration
This appliance is shipped in the top vent configuration. To change to the rear vent configuration, follow
the directions below.
NOTE: Top or rear vent configuration affects several aspects of installation (framing, maximum vent rise,
maximum vent run). Make sure the vent configuration is correct prior to installation.
HINT: The diffuser is easiest to modify when converting the vent to rear-vent configuration. Refer to the
vent configuration charts to determine if the vent diffuser requires adjustment to position # 2.
Converting the Fireplace to Rear Vent Configuration
Remove the outer flue
assembly. Place the screws
and components aside (for
all subsequent steps).
Remove the cover
plate, and heat shield.
Remove the inner flue assembly
and exhaust cover plate.
Travis Industries
Installation
(for qualified installers only)
NOTE: Use a magnetic-tipped
nutdriver on these screws - take
care to prevent the screws from
falling into the fireplace.
Cover Plate
Inner Flue
Assembly
Exhaust Cover Plate
4140312
Heat Shield
11
100-01305