Travis Industries 864 ST Installation Manual page 57

Optional Equipment
4 Carefully place the floor
firebacks into position.
You must tip them under
and around the corners
of the burner.
5 Carefully replace the
front and rear grates
(they rest on top of the
floor firebacks).
6 Install the side firebacks
following the directions
below.
7 Restore the fireplace to
the correct
configuration.
The ceramic firebacks are fragile. Ensure proper alignment of individual pieces in each step. To achieve
the ideal appearance, you may need to make slight adjustments.
© Travis Industries
(for qualified installers only)
NOTE: These tabs are bent out when using the accent light. Make sure
to carefully bend them flush if the accent light was previously installed
(then reposition them after firebacks are installed).
4071126
Remove the clips on both sides (loosen the screws
a
a couple turns and slide clips up and out).
5/16" Nutdriver
Place the side firebacks into position.
b
Secure the clips to anchor
c
the side firebacks.
100-01195_000
57