Nailing Brackets - Travis Industries 864 ST Installation Manual

Finalizing the Installation

Nailing Brackets

There are eight nailing brackets on the front and
back of the fireplace. Follow the directions below
to prepare the
nailing brackets. Once in
place, nail or screw the
nailing brackets to the
framing.
NOTE: Additional nailing brackets are
provided along the base of the
fireplace. Use these brackets if not
using the front brackets.
NOTE: You may need to bend the
tabs out on one side then slide the
fireplace out to bend the tabs out on
the opposite side
1/2" Drywall
For installations using 1/2" facing
fold the larger tabs out 90° on
the right side (use a screwdriver
if necessary). Bend the tabs out
on the left side
5/8" Drywall
For installations using 5/8" drywall fold the shorter tab
out 90° on the right side. (use a screwdriver if
necessary). On the left side, remove the side standoff
(screws hold it in place) and re-attach it in the
alternative holes provided.
© Travis Industries
(for qualified installers only)
TOP VIEW
Fireplace
TOP VIEW
Fireplace
4071126
13
WARNING: Make sure the
fireplace is square and plumb
when placed in the framing.
Measured corner-to-corner, the
fireplace should be square
(approx. 54-7/8" for each
dimension). Use shims to
insure the fireplace is square.
Framing
Nailing Bracket
Drywall
Framing
Nailing Bracket
Drywall
100-01195_000