Finalizing the Installation
Approved Vent
•
Side vent configurations use 8" diameter Simpson Dura-Vent Model Pro or GS vent.
•
Top vent configurations use 8" or 6-5/8" diameter Simpson Dura-Vent Model Pro or GS vent. If
using 6-5/8" diameter vent, attach the 8" to 6-5/8" reducer (Travis part # 98900165) to the
fireplace.
Vent Installation
•
Slide the vent sections together and turn 1/4 turn until the sections lock
in place.
•
Screws are not required to secure the vent. However, three screws may
be used to secure vent sections together if desired.
•
High temperature sealant is recommended at the appliance starter
section connection (use high-temperature silicone or Mill-Pac®).
•
If disassembly is required, at time of re-assembly check to see if the vent
creates a tight fit. If it does not, apply high temperature sealant to the
joints of the affected sections.
•
Horizontal sections require a 1/4" rise every 12" of travel.
•
Horizontal sections require non-combustible support every three feet (e.g.: plumbing tape).
© Travis Industries
6-5/8" Diameter Vent
Reducer - # 98900165
4071126
(for qualified installers only)
19
100-01195_000