Connections of the Monitor
DC Voltage
The DC voltage to operate the SPARROWHAWK LSM 124W / LSM 127W video monitors will be
supplied by an external Power Supply. The connection happens with a XLR 5pin port at the rear.
The pin-out of the XLR5M port is shown in following table:
Power Supply
Interconnect the mains output using a reliable cord with the IEC port of the external Power Supply.
The pin-out of the IEC port is shown in following table:
AC Voltage
The voltage to operate the SPARROWHAWK LSM 132W ./. LSM 182W video monitors will be supp-
lied by an internal Power Supply. Interconnect the mains output using a reliable cord with the IEC port
of the internal Power Supply.
The pin-out of the IEC port is shown in following table:
© 02.07 TAMUZ - LCD Video Monitors
Pin
Pin
1 (N)
2 (P)
3 (GND)
Pin
1 (N)
2 (P)
3 (GND)
Note: Warning about dangerous electrical voltages to or within the equipment. Take care to
use the correct power cord depending to your local electricity safety system.
Function
1
Ground
2
NC
3
NC
4
NC
5
+ 12 V DC
Function
Neutral
Phase
Ground
Function
Neutral
Phase
Ground
LSM Digital Broadcast Monitor
SPARROWHAWK
Page - 24 -