Disturbed Bve Images; Modification At The Bve 2000 - TAMUZ LSM 124W Operation Manual

Individual Adjustments and Setups

Disturbed BVE Images

At appearance of reflections and jitter in the picture the used cable is of unsatisfactory quality. Particu-
larly at cables with an extra shield this shield creates capacitive disturbances usually.
For cable length over 5 meter, high-end non-shielded coax are recommended.

Modification at the BVE 2000

At the Sony BVE 2000 editors with serial number larger then 15000 a modification is necessary. Wi-
thout this modification the VDU output don't sends a expectable sync signal for the LCM 100 Broad-
cast Series interface.
At the video board (upper board) condenser C181 (close by IC61 at the back connector) is obsolete
and has to be replaced by an 75 Ohms resistor.
© 02.07 TAMUZ - LCD Video Monitors
Note: The cable shield have to be grounded at the Sub-HD15M side only. Don't connect the
shield at the Sub-D9M side ever!
Note: Disconnect the shield at the Sub-D9M side ever! Check that no GROUND is at the
SHIELD at the Sub-D9M connector.
Note: Be careful when you modify the Sony BVE 2000 editor. Ask your technical service for
assistance. With this modification done the original warranty may be lost.
LSM Digital Broadcast Monitor
SPARROWHAWK
Page - 105 -