Service Interface; Probe Interface - TAMUZ LSM 124W Operation Manual

Connections of the Monitor

Service Interface

For some special application a so-called service interface is helpful to control or maintain the monitor
firmware by external devices, like a PC system.
This service interface is built-in the GPI/O port. The pin-out is shown in following table:
Pin
This port is available for the SPARROWHAWK LSM 1xxW series monitor (factory built-in at order).
This service interface can be used by service technicians to update the firmware. A special adapter
cable is necessary to connect to a PC RS232.

Probe Interface

All TAMUZ SPARROWHAWK series models have a probe port built-in at the front for alignment
applications. This port communicates with a color probe, like the TAMUZ AAC probe PM5639-T.
This port is standard at the SPARROWHAWK LSM 1xxW series monitors.
This service interface can be used by service technicians to align the monitor in colormetry and bright-
ness.
© 02.07 TAMUZ - LCD Video Monitors
Function
1 GPI Tally Green, closed contact +
2 GPI Tally Red, closed contact +
3 GPI 16:9 / 4:3, closed contact +
4 GPI Input SDI 1, closed contact +
5 GPI Input SDI 2, closed contact +
6 GPI Input SDI 3, closed contact +
7 GPO Input SDI 1 active, +5 V
8 GPO Input SDI 2 active, +5 V
Note: Do not connect other equipment then the recommended RS232 adapter to this port.
The monitor and the connected device may become destroyed.
Note: Do not connect other equipment then the recommended color analyzer probe to this
port. The monitor and the connected device may become destroyed.
Pin Function
9 GPO Input SDI 1 active, +5 V
10 Ground (GND)
11 Not Connected
12 Not Connected
13 RS 232 +
14 RS 232 -
15 Ground
LSM Digital Broadcast Monitor
SPARROWHAWK
Page - 30 -