Size Switch - TAMUZ LSM 124W Operation Manual

Operation
wide screen monitor in 1:1 mode, 576i signal at input
Anamorphic signals will be shown in the correct aspect ratio. Under 16:9 conditions standard 4:3 si-
gnals are shown in a horizontal stretched mode.
As default the active video area will be shown. The interface of the monitor SPARROWHAWK series
is capable to show the full video signal, in case of PAL formats up to 625 TV lines or in case of NTSC
formats up to 525 TV lines. Therefore you must adjust the setup for scanning TV lines in the menu
step GEOMETRY - SETTINGS - INPUT - LINES. The aspect ratio in a suitable way must corrected is after this.

Size Switch

Corresponding to the operation keys at a normal monitor use the IR-remote keys to operate the
SPARROWHAWK series monitors. Using the button DOWN when the main menu is not active, you
may toggle between different size modes of the SPARROWHAWK series monitors.
If the SIZE button is pushed once, the displayed size of the image can be selected between the UN-
DERSCAN – NORMAL – OVERSCAN - ZOOM mode (see image below). The aspect ratio will be set to
the corresponding values.
standard monitor in NORMAL mode, 576i signal at input
© 02.07 TAMUZ - LCD Video Monitors
Note: The 16:9 and 4:3 aspect ratio formats are selectable as default. If another aspect ratio
or anamorphic conversion is necessary, refer the service section of this manual to adjust your
individual setup.
standard monitor in 1:1 mode, 576i signal at input
standard monitor in UNDERSCAN mode, 576i signal at input
LSM Digital Broadcast Monitor
SPARROWHAWK
Page - 34 -