Service Section; Changing A Faulty Fuse; Step: Open The Monitor; Step: Exchange The Fuse - TAMUZ LSM 124W Operation Manual

Service Section

Service Section

Changing a faulty Fuse

The electronics of the SPARROWHAWK LSM 1xxW series monitor is protected by an integrated fu-
se. The fuse is placed on the interface board. In case of an electronic defect or any other reason of
drawing a high current, the fuse will release. To exchange the fuse, you need to open the monitor and
replace the broken fuse with a spare (2 A MT type 20 x 5 mm).

1. Step: Open the Monitor

To exchange the broken fuse, you have to open the SPARROWHAWK LSM 1xxW series monitor.
Use a 2,5 mm allen-key screw driver to turn out the eight screws at the monitor front cover.
After turning off the eight screws, open carefully the monitor housing.
The front panel contains the LCD screen and the interface board. Flip the unit down.

2. Step: Exchange the Fuse

The internal fuse is placed on the interface board (highlighted in the picture below).
Take the broken fuse out of his setting and replace with a spare. (2 A MT type 20 x 5 mm)

3. Step: Reassemble the Monitor

Finally you can reassemble the monitor as described in step 1.
© 02.07 TAMUZ - LCD Video Monitors
Note: Be careful during turning off the screws at the monitor front. Us the correct screw driver
to open the screws.
Note: Do not use a different fuse type as described, the monitor can otherwise be destroyed.
LSM Digital Broadcast Monitor
SPARROWHAWK
Page - 118 -