Submenu Measure - TAMUZ LSM 124W Operation Manual

Main Menu

Submenu Measure

Select the MEASURE MENU from the AUTO COLOR MENU with the UP and DOWN keys and open the me-
nu step with the PLUS (V+) key.
The MEASURE MENU shows following operational steps:
Auto Color
Probe Setup
Calibrate
Brightness
Measure
Status
x
y
Y cd/m 2
Whitepoint x
Whitepoint y
User Gamma
Close and save this menu step by pushing the MENU key once.
© 02.07 TAMUZ - LCD Video Monitors
2
Idle
0
0
0
307
321
Note: Any calibration should be done in a dark environment ( ~8 cd/m
the ITU, SMPTE or EBU recommendations.
Note: The MEASURE menu stops immediately when no probe is connected to the monitor
and indicates „ERROR" in the status field!
The OSD reacts slowly to commands, cause the system is searching for a probe!
Note: The MEASURE window will be still visible, even when the OSD menu is switched off,
until the measure feature is definitely finished.
315
329
90
The measurement feature opens a new window
showing the currently measured x / y / Y values. The
window will be still visible even when you select a
different menu, f.e. To adjust the brightness manually,
until the measurement feature will be finished.
Indicates the measurement activity!
Only when „READY" is shown, the measurement is
LSM Digital Broadcast Monitor
SPARROWHAWK
Help
finished and set.
2 ) as recommended by
Page - 85 -