Submenu Calibrate - TAMUZ LSM 124W Operation Manual

Main Menu

Submenu Calibrate

Select the CALIBRATE MENU from the AUTO COLOR MENU with the UP and DOWN keys and open the me-
nu step with the PLUS (V+) key.
The CALIBRATE MENU shows following operational steps:
Auto Color
Probe Setup
Calibrate
Brightness
Measure
Status
x
y
Y cd/m 2
Whitepoint x
Whitepoint y
User Gamma
Close and save this menu step by pushing the MENU key once.
© 02.07 TAMUZ - LCD Video Monitors
2
Idle
0
0
0
307
321
Note: Any calibration should be done in a dark environment ( ~8 cd/m
the ITU, SMPTE or EBU recommendations.
Note: The CALIBRATE menu stops immediately when no probe is connected to the monitor
and indicates „ERROR" in the status field!
The OSD reacts slowly to commands, cause the system is searching for a probe!
Help
The color calibration is an automatically process and
starts with some full color patterns to measure the
color space of the specific monitor TFT Panel.
Thereafter a ramp black-to-white will be measured to
write the individual LUT. The whole calibration take
about 4 to 10 minutes.
Indicates the measurement activity!
Only when „READY" is shown, the measurement is
finished and set.
LSM Digital Broadcast Monitor
SPARROWHAWK
2 ) as recommended by
Page - 83 -