How To Set-Up - Britax Maxi Rider Instructions For Installation & Use

Convertible booster seat for vehicle use
Hide thumbs Also See for Maxi Rider:
Table of Contents

Advertisement

FOR
TODDLER
USE
ADJUSTING SHOULDER HARNESS STRAPS HEIGHT
Correct fitment of the harness is very important as it restrains the child in the restraint. The
harness must fit firmly around the upper torso of the child and be
positioned so as to leave the child's arms and legs free.
FOR TODDLER USE: The shoulder straps must be in the slots
which are nearest to the child's shoulders, but not more than
25mm below the child's shoulders. If when in the top slots,
the harness straps are more than 25mm below the level of
the child's shoulders or child weighs more than 18kg, then
the child is too large for the harness straps and the restraint
should be now used as a booster. (Booster Mode - see
pages 15 onwards).
The shoulder straps must be
in the slots which are
nearest to the child's
shoulders, but not more
than 25mm below the
child's shoulders.
Front of vehicle
STEPS IN CHANGING SHOULDER STRAP SLOTS
A.
Remove the restraint from vehicle as instructed on page 7.
B.
At the rear of the restraint, remove one of the harness
shoulder straps from metal Strap Connector by slipping
strap through open slot. The metal Strap Connector is
shown in diagram right.
C.
From the front, pull the shoulder strap out through
shoulder slot.
D.
Insert shoulder strap through restraint slot which will
position shoulder strap level with or above the child's
shoulder, shown above. Ensure that the Shoulder strap
passes through matching slots in cover and restraint body.
E.
Ensure there are no twists in the harness strap and the buckle tongues face the
correct way.
F.
Connect shoulder strap to metal strap connector at rear of restraint.
G.
Repeat for other shoulder strap. It is better to change one strap at a time so that
the other strap will be a guide for re-assembly.
WARNING: Do not use the restraint with harness shoulder straps set at different
heights or fed through mis-matching slots. Ensure harness straps are not
twisted and that all straps are secure by pulling each harness strap.
10
Forward Facing (8 kg to 18 kg)
HOW TO SETUP
8
8
1
1
2 2
3 3
4 4
5 5
6 6
7 7
Upper shoulder strap slots.
1.
Mid shoulder strap slots.
2.
3.
Lower shoulder strap slots.
Shoulder harness straps.
4.
Harness tongues & buckle.
5.
Lap strap slots.
6.
Crotch strap slots.
7.
8.
Top (4 ) row of shoulder slots
th
(only where provided and only
for Child Safety Harness).
4 4
6 6
7 7
Strap Connector

Advertisement

Table of Contents
loading

This manual is also suitable for:

Safe-n-sound maxi rider8000/a/2004 series

Table of Contents