Table of Contents
Advertisement
USING WITH CHILD HARNESS
D.Engage the seat belt tongue to the buckle and adjust the seat belt to sit firmly but
comfortably around the child's pelvis. The seat belt buckle should be located as low as
possible below the child's hip.
Pull Adjustment Strap
Fully press Adjuster
Button (A) while pulling
Upper Anchorage
Strap (B) to lengthen.
Adjuster
E.
With the lap belt (or converted lap/sash) adjusted to be a firm fit on the child's
thighs, then adjust the Protecta™ Child Safety Harness to remove all slack in the
shoulder straps. Once adjusted, further adjustments are necessary only to the
upper extension straps and to accommodate the growth of the child.
Use the reverse procedure to remove the child from the harness.
F.
Finally, roll up the free end of the adjuster strap, secure using the storage strap,
then place it into the top of the adjuster cover as shown above.
When not in use, the harness may be flipped onto the parcel shelf or disconnected
from the anchor fitting and stored.
WARNING: The lap portion of the belt must be
adjusted firmly first, and then the harness, so
that the belt is not lifted off the child's
lap when the harness is adjusted.
If fitted, fit the Anti Submarining Clip
to the lap belt, centrally between the
shoulder straps of the harness loops,
ensuring that the Red button of the
crotch buckle is facing forward.
to remove slack.
B
A
Lap portion of belt must be under
armrest on both sides.
Forward Facing (14 kg up to 26 kg)
(Not Supplied)
Roll up Adjuster Strap and
secure with Storage Strap.
Storage
Strap
Remove Anti-Submarine Clip
from recess area and engage
Engage seat belt buckle and
tongue.
Adjuster
Cover
Click
into harness buckle.
25
Hide quick links:
Advertisement
Table of Contents
