Britax Maxi Rider Instructions For Installation & Use page 23

USING WITH CHILD HARNESS
CHOOSING METHOD OF INSTALLATION
The Protecta™ Child Safety Harness can be installed using either of the following
methods.
METHOD 1 : Using a lap sash seat belt in
conjunction with Gated Slide provided to
convert to lap belt plus upper anchorage strap.
METHOD 2 : Using lap seat belt plus upper
anchorage strap.
Before installing the Protecta™ Child Safety
Harness determine which method of
installation is required and follow instructions
carefully.
NOTE: If fitted, the Anti-Submarining clip should
be used when the child is using the booster
seat with the child harness.
When using the Protecta™ Child Safety Harness,
ensure the 'built-in' shoulder harness is rolled up and
stored in the recesses under the cover. Refer to pages
17-18 on storing the harness. If the Anti-Submarining clip (if fitted) is not being
used, then it, and the crotch buckle must also be stored in the recesses under the
cover. Roll up the metal connector and tuck it into the recess in the recline foot at the
back of the seat.
Important Note: Some vehicle seat belts are too short and you may experience some
difficulty fitting the converted lap-sash around your child. If so, adjust the gated slide
nearer to your child, ideally under the armrest and lap belt recess area, (ensure the
slide does not touch your child). This should provide more belt length to fit your child,
but if the belt still will not fit, try another location in the vehicle, eg. side seat. If the
vehicle belts are still too short, then contact the vehicle manufacturer for advice on
longer seat belts.
A.Feed the LH Harness Strap & Cross
Strap through the appropriate
shoulder slot.
Feed LH
Harness Strap &
Cross Strap
through
appropriate slot.
(Not Supplied)
Sash Locator
& Right Shoulder
Strap with Tongue
B. Pull the LH Harness Strap & Cross Strap
through the opposite shoulder slot. Make
sure that the Anchor Clip also feeds
through to the back of the restraint. Hook
the Attachment Clip onto the Harness
Catch and ensure that the straps line up to
an equal length.
Hook the Attachment Clip
onto Versa-Tether™
Catch.
Forward Facing (14 kg up to 26 kg)
Left Shoulder
Strap with Tongue
Crotch Buckle with Anti-
Submarining Clip engaged.
Pull LH Harness
Strap through
opposite slot until
the straps are of
equal length.
23