Britax Maxi Rider Instructions For Installation & Use page 24

USING WITH CHILD HARNESS
NOTE: Some versions of the Maxi Rider have been provided with an extra (4th) row of
shoulder slots, which are only available for use if there are matching slots in the trim
(cover). These extra slots are only for use with the Protecta™ Child Safety Harness
and should not be used for the integral Harness.
METHOD 1: USING LAP-SASH SEAT BELT WITH
PROTECTA™ CHILD SAFETY HARNESS.
(Using Gated Slide provided with Child
Harness.)
Refer to Protecta™ Child Harness
instruction to fit gated slide.
Fit the Protecta™ Child
Safety Harness as detailed
on page 23. Then connect the
cross strap as shown below. Thread
the converted lap-sash seat belt
through the harness strap loops
as shown right.
METHOD 2: USING LAP SEAT BELT WITH
PROTECTA™ CHILD SAFETY HARNESS.
Fit the Protecta™ Child Safety Harness as
detailed on page 23. Then connect the
cross strap as shown below. Thread the
lap seat belt through the harness strap
loops as shown right.
Connect the Protecta™ Child Safety Harness to the
Versa-Tether™ Catch as detailed on page 22.
A. With the child seated, place each of the
harness straps over each shoulder.
B. Feed the RH strap (loop end) into
the cross strap loop to connect
the two sides.
C. Feed the adult belt (lap belt or
converted lap/sash) through
the harness loops, ensuring
that the cross strap loop does
not disconnect. Also ensure
there are no twists in the
harness, cross strap and
seat belt.
24
Forward Facing (14 kg up to 26 kg)
Converted
lap-sash
seat belt.
Fit Gated Slide here.
Storage
Strap
RH Harness
Strap Loop
Cross Strap
Loop
Cross Strap
(Not Supplied)
RH Harness
Strap
Harness
strap loops
Harness
strap loops
LH Harness
Strap
Cover Pad
(Not shown)