Britax Maxi Rider Instructions For Installation & Use page 18

C. Pull the shoulder straps through slots in the seat back.
D. Remove the Elastic loops holding the cover in place at the lower front of the seat. Lift the
cover to expose the storage inserts in the seat base.
E. Remove Sash Locator strap and clip from storage recess and attach to the strap connector
plate as shown below (Make sure straps are not twisted).
F. Then thread the sash guide through the shoulder strap slot nearest your seat belt.
G. Feed the straps with harness buckle tongues through the bottom rear of the seat cover. Roll
up the harness straps with harness buckle tongue and place them into the left and right rear
recess in the seat base (underneath the cover).
H. Remove Anti Submarine Clip from storage recess and engage into harness buckle. See page
20.
I. Adjust the crotch strap length if necessary. See page 19.
J. Align cover and re-engage elastic loops at the front of the cover.
K. Store shoulder pads (if fitted) in a safe place, for future use.
18
Forward Facing (14 kg up to 26 kg)
HOW TO SET-UP
Feed Sash
locator Clip
through
appropriate slot.