Bombardier-Rotax FR 125 MAX FR 125 Junior MAX Installation And Operator's Manual page 65

Installation Instructions FR 125 MAX and FR 125 Junior MAX
Note: Polarity of the cable for start button and ON/OFF circuit breaker doesn't matter.
Attach the ignition coil as shown on illustration (fig. 5) on the reduction gear cover,
utilizing the supplied attachment elements (2 x rubber mount, pos. 3,4; 4 x washer,
pos. 7 and 4 x lock nut, pos. 8).
Note: On the top attachment screw of the ignition coil connect also the additional
grounding cable (pos. 38).
Note: The location of the ignition coil is adjustable within the oblong holes in gear cover
and ignition coil yoke. Position ignition coil as far as possible from the exhaust
system.
Attention: The ignition coil must be attached flexible on the gear cover, exclusively via the two
rubber mounts. Make absolutely sure that the ignition coil will not touch at no
situation or vibration rigid parts of the frame (e.g. seat strut).
Note: The battery should only be connected just before starting the engine.
Connect the wiring harness on the trigger coil (pos. 1).
Connect the wiring harness on the ignition coil (pos. 4).
Connect the wiring harness on the electric starter (pos. 9 ).
Attach the wiring harness with the supplied cable ties to top side of chassis tubes
and in the area of the ignition coil support; make sure that the plug connections on
the ignition pick-up and ignition coil are free of stress.
Note: Compensate excessive length of wiring harness by routing cables in loops.
Warning: The wiring harness must not touch moving parts of the track.
Attention: Pay special attention to proper ground connection on gear compartment cover. An
interrupted grounding can ruin the ignition coil.
Note: When unplugging connections on ignition pick up and ignition coil, press the
integrated catch first.
Note: Disconnect any electrical plug connection only by pulling on the plugs.
Seite/page 65/108 Ausgabe/edition 09.2003