Completing The Installation; Seasonal Heat Dump Adjustment; Glass Frame Assembly Installation - kozy heat Lakefield 56150 Installation And Operation Manual

COMPLETE THE INSTALLATION
THIS STEP SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER OR SERVICE TECHNICIAN
Perform lighting and shutdown procedures as described on page 17. This should be done prior to replacing the glass so that any necessary adjust-
ments can be made and proper operation verified.
SEASONAL HEAT DUMP:
This fireplace has been manufactured with an adjustable heat dump outlet inside the firebox (at the top). This will allow infinite control over the
amount of heat emitted into the living area without affecting the flame.
CAUTION: IF THE FIREPLACE HAS BEEN IN OPERATION, ALLOW AMPLE TIME FOR IT TO COOL BEFORE ADJUSTING THE HEAT OUTLET
OPENING OR USE THE APPROPRIATE PROTECTION TO PREVENT SERIOUS BURNS.
ATTENTION INSTALLER: Please install the fireplace with this heat vent damper in the closed position.
TO ADJUST: Remove the glass assembly, open or close the damper as desired, then replace the glass assembly.
HEAT OUTLET SHOWN
IN CLOSED POSITION.
RE-INSTALL GLASS FRAME & CAST IRON DOOR ASSEMBLY
A) Align the slots in the top of the glass assembly over the tabs on the fireplace.
B) Place the glass assembly so it is flush with the front of the fireplace front.
C) Pull the knobs on the latching mechanism first out, then up and release.
D) The glass assembly is now secured.
E) Align mounting brackets on the back side of cast iron door assembly onto the mounting rod at the top of the fireplace and set down into position. The
door assembly should set between the side frames.
WARNING: DO NOT OPERATE THIS FIREPLACE WITH THE GLASS ASSEMBLY REMOVED, CRACKED OR BROKEN. Replacement
of the glass assembly #700-15T, should be done by a licensed or qualified service person.
IN PARTIAL OPENED POSITION.
PAGE 16
HEAT OUTLET SHOWN