Completing The Installation ( Re-Install The Glass Assembly, Upper & Lower Grills) - kozy heat 942 Installation & Operating Manual

I) COMPLETE THE INSTALLATION
1. SECURE THE FIREPLACE:
Nailing flanges are attached to the sides of the fireplace.
A. Loosen, but do not remove the screws securing the nailing flanges at the sides of the fireplace and remove the
nailing flanges.
B. Locate the keyhole slots on the nailing flange & place the nailing flange over the screws.
C. Slide the nailing flange forward to the desired position & tighten screws.
C. The nailing flanges can now be bent parallel with the face.
D. Fasten to framing through the holes in the nailing flange.
NOTE: Two set of holes have been provided to accommodate various depths.
2. Complete the fireplace walls and facing.
CAUTION: THE SURROUNDING WOOD CHASE OF THE OUTSIDE WALL MUST BE INSULATED TO PREVENT COLD
AIR FROM ENTERING THE ROOM.
2. THIS STEP SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER OR SERVICE TECHNICIAN:
A. Perform lighting and shutdown procedures as described on pages #24-#25. This should be done prior to re-
installing the glass so that any necessary adjustments can be made and proper operation verified.
3. Re-install the glass assembly. Figure 15.
A. Align the slots in the top of the glass assembly over the
tabs on the fireplace.
B. Place the glass assembly so it is flush with the front of
the fireplace front.
C. Secure the assembly to the fireplace by pulling the
spring-loaded latch rods out, then up and releasing
them onto the brackets securing the glass assembly
(located under the firebox).
WARNING: DO NOT OPERATE THIS FIREPLACE WITH THE
GLASS ASSEMBLY REMOVED, CRACKED OR BROKEN.
Replacement of the glass assembly should be done by a
licensed or qualified service person.
4. Install the upper grill. Refer to Figure 15.
A) Line the rods of the grill up with the upper holes.
B) Place the rods in the holes and push up until the
bottoms of the rods clear the valance.
C) Place the bottom of the rod into the lower holes and
release. The grill will set down into place.
5. Install the lower grill. Refer to Figure 16.
A) Place one of the bolts through the hinge in
the lower grill opening (A) & attach the
1/4" nut (B).
B) Repeat for remaining hinge.
C) Tighten both 1/4" nuts.
The grill is now in place and may be lowered
for lighting purposes, etc.
Figure 15
Page 22
Figure 16