Configuring Ptz Settings; Figure 9-2 Ptz Settings Menu - Honeywell HRG4 User Manual

92 | Performance Series DVR User Guide
Menu items include:
•
•
•
•
•
•
•
•
•

Configuring PTZ Settings

Settings for a PTZ camera must be configured before it is used. Before proceeding, verify that
the PTZ and RS-485 of the DVR are connected properly.
To configure PTZ settings:
1.
2.
3.
4.
www.honeywellvideo.com
Camera: Select a PTZ camera.
Call Preset: Call a PTZ preset.
Call Patrol: Call a PTZ sequence.
Call Pattern: Call a PTZ pattern.
Preset Settings: Enter PTZ preset configuration menu.
Patrol Settings: Enter PTZ sequence configuration menu.
Pattern Settings: Enter PTZ pattern configuration menu.
PTZ Menu: Enter PTZ control menu.
PTZ Settings: Enter PTZ settings menu.
 
Click Menu Settings
Figure 9-2 PTZ Settings Menu
Next to Camera, select the channel where PTZ camera is installed.
Set the Baudrate, Data Bit, Stop Bit, Parity, Flow Control, PTZ Protocol, and Address.
Click OK to save the settings and exit the menu.
Note All setting parameters (baud rate, data bit, stop bit, parity, flow control, PTZ
protocol and address) must be consistent with the PTZ camera connected.
PTZ to enter the PTZ Settings menu (see Figure 9-2).