Table of Contents
Advertisement
Replacing Gateway Convertible Notebook Components
Replacing the modular drive
Important
Tools you need to complete this task:
To replace the modular drive:
1
Complete the steps in
2
Turn the convertible notebook over so the bottom is facing up.
3
Remove the modular bay lock screw (if one is present), then slide and hold the module
bay latch. The drive may move out slightly.
10
Install only a Gateway CX200 modular drive in the modular bay.
Phillips #0 screwdriver
"Preparing the convertible notebook" on page
Modular bay lock screw
www.gateway.com
6.
Advertisement
Table of Contents
Need help?
Do you have a question about the Convertible Notebook pc and is the answer not in the manual?
Questions and answers