Table of Contents
Advertisement
Figure 18. Inserting an LC-LC Fibre Channel cable into an installed SFP module
5. Remove the two protective caps from the other end of the LC-LC cable, as
6. Connect the LC-LC Fibre Channel cable to one of the following devices:
Removing an LC-LC Fibre Channel cable
To remove an LC-LC Fibre Channel cable, do the following:
Attention:
press and hold the lever to release the latches before you remove the cable from
the SFP module. Ensure that the levers are in the released position when removing
the cable. When removing the cable from the SFP module, make sure you do not
grasp the SFP module plastic tab.
1. On the end of the LC-LC cable that connects into the SFP module or host bus
Figure 18 shows an LC-LC Fibre Channel cable connecting into an SFP module
that is installed in a FAStT700 Storage Server mini hub.
SFP module
Fiber-optic
cable
shown in Figure 16 on page 20. Save the protective caps for future use.
v SFP module that is installed in an IBM Fibre Channel switch
v Optical interface connector on an IBM FAStT FC-2 Host Bus Adapter (Part
Number 19K1246)
v LC-SC Fibre Channel cable adapter (For information about using an LC-SC
cable adapter, see "Using LC-SC Fibre Channel cable adapters" on page 22.)
For more information about connecting to these devices, see the documentation
that comes with the device.
To avoid damaging the LC-LC cable or SFP module, make sure you
adapter, press down and hold the lever to release the latches, as shown in
Figure 19 on page 22. Carefully pull on the connector to remove the cable from
the SFP module, as shown in Figure 20 on page 22.
2 G
b /s
1 G
b /s
!
2 G
b /s
1 G
b /s
O U
!
T
2 G
b /s
1 G
b /s
O U
T
!
2 G
b /s
1 G
b /s
O U
T
!
I N
O U
T
I N
I N
I N
Chapter 2. Connecting the FAStT700 Storage Server
21
Advertisement
Table of Contents
