Table of Contents
Advertisement
Refer to the documentation provided with your host adapters for installation
requirements and procedures.
After you install the cluster server hardware, continue with "Installing drive
enclosures in a rack cabinet" or go to "Chapter 2. Connecting the FAStT700
Storage Server" on page 13.
Installing drive enclosures in a rack cabinet
Install the drive enclosures that you are attaching to the FAStT700 Storage Server
in a rack cabinet. Preparing the drive enclosures for installation in a rack cabinet
might involve any or all of the following tasks:
v Moving the drive enclosures to the installation site
v Unpacking the drive enclosures from their shipping cartons
v Checking the shipping contents
v Removing all customer replaceable units (CRUs)
For detailed instructions on installing the drive enclosures in a rack cabinet, refer to
the documentation that comes with each device. After you install the drive
enclosures, go to "Chapter 2. Connecting the FAStT700 Storage Server" on
page 13.
README file for information on supported host adapters and device drivers. This
information is found on the IBM FAStT Storage Manager installation CD or at
http://www.ibm.com/pc/support/.
Make sure each host adapter and controller has a unique Fibre Channel ID.
11
Chapter 1. Introduction
Advertisement
Table of Contents
