Step 7. Installing The Enclosures; Hole Locations In The Back Of The Rack - IBM Storwize V7000 Quick Installation Manual

2 Units
Figure 13. Hole locations in the back of the rack
10. Repeat the steps to secure the opposite rail to the rack cabinet.
11. Repeat the procedure for each additional enclosure.

Step 7. Installing the enclosures

CAUTION:
1. To lift and install the enclosure into the rack requires at least two people.
2. Load the rack from the bottom to ensure rack stability. Empty the rack from
Following your enclosure location plan, install the correct type of enclosure starting
from the bottom.
1. On either side of the drive assemblies, remove the enclosure end caps by
16
Storwize V7000 Unified: Quick Installation Guide
3
2
1
1 Bottom rail location pin hole
v
2 Rack mounting screw hole
v
3 Top rail location pin hole
v
7. Insert the rail location pins through the holes 1 and 3 in the rack cabinet.
8. Insert a clamping screw into the rack mounting hole 2 between the rail
location pins.
9. Tighten the screw to secure the rail to the rack from the back side.
the top down.
squeezing the middle of the cap and pulling it away from the front of the
enclosure .