Accessories, Consumables - Hilti TE 1000-AVR Operating Instructions Manual

2.10 Items supplied as standard
1 Power tool
1 Side handle
1 Grease
1 Cleaning cloth
en
1 Operating instructions
1 Hilti toolbox
2.11 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise lose performance and the extension cord may overheat. Check the extension
cord for damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 110-120 V
Do not use extension cords with 16 AWG conductor cross section.
2.12 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
2.13 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled:
The unit must provide a power output in watts of at least twice the value printed on the type identification
plate on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all
times, frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with
automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.

3. Accessories, consumables

TPS Theft Protection System with Company Card, Company Remote
and TPS K key
Dust removal module
Use the Hilti chisels or other tools listed below. With these chisels and tools you will achieve higher
performance and longer lifetime as the power tool and chisels have been optimized as a system.
TE-S chuck
Pointed chisels
4
14 AWG
75 m (246.06 ft)
TE DRS B
Designation Width (mm)
TE SP SM 36
TE SP SM 50
TE SP SM 70
12 AWG
125 m (410.1 ft)
Option, 206999
Width in
Length (mm)
inches
360
500
700
Length in
inches
14
20
27