Before Use; Operation - Hilti TE 1000-AVR Operating Instructions Manual

5.2.4 Work area
a) Ensure that the workplace is well ventilated.
Exposure to dust at a poorly ventilated workplace
may result in damage to the health.
b) Keep the workplace tidy. Objects which could
cause injury should be removed from the working

6. Before use

6.1 Fitting and adjusting the side handle 2
1. Disconnect the supply cord plug from the power
outlet.
2. Release the side handle clamping band by turning
the knob.

7. Operation

DANGER
Always hold the power tool securely with both hands
on the grips provided. Keep the grips dry, clean and
free from oil and grease.
7.1 Preparing for use
CAUTION
Wear protective gloves when changing insert tools
as the insert tools get hot through use and they may
have sharp edges.
area. Untidiness at the workplace can lead to
accidents.
c) If the work involves breaking right through, take
the appropriate safety measures at the opposite
side. Parts breaking away could fall out and / or
fall down and injure other persons.
d) Approval must be obtained from the site engineer
or architect prior to beginning the work. Work on
buildings and other structures may influence the
statics of the structure, especially when steel
reinforcing bars or load-bearing components are
cut through.
3. Relax the tension on the side handle clamping
band and slide it over the chuck and onto the
cylindrical section at the front end of the power
tool.
4. Pivot the side handle into the desired position.
5. Secure the side handle by tightening the knob.
6.2 Unlocking the power tool (theft protection
system)
See section "Operation / TPS Theft Protection System
(optional)".
6.3 Use of extension cords and generators or
transformers
See section "Description / use of extension cords".
7.1.1 Fitting the chisel or other tool 3
NOTE
The chisel can be adjusted to 6 different positions (in
60° increments). This ensures that flat chisels and
shaped chisels can always be set to the optimum
working position.
1. Disconnect the supply cord plug from the power
outlet.
2. Check that the connection end of the chisel is
clean and lightly greased. Clean it and grease it if
necessary.
en
9