Display And Debug Rip - 3Com 7700 Configuration Manual

74 C 5: R P
HAPTER OUTING

Display and Debug RIP

Example: Typical RIP
Configuration
O
ROTOCOL PERATION
Table 19 Configure RIP to Filter Routes
Operation
Cancel filtering the received
routing information distributed by
the specified address
Configure filtering the received
global routing information
Cancel filtering the received global
routing information
Configure RIP to Filter Distributed Routes
Configure RIP to filter the
distributed routing information
Cancel the RIP filtering of the
routing information
By default, RIP does not filter received and distributed routing information.
After configuring RIP, execute the display command in all views to display the RIP
configuration, and to verify the effect of the configuration. Execute the
debugging command in user view to debug the RIP module.
Table 20 Display and Debug RIP
Operation
Display the current RIP running
state and configuration
information.
Enable the RIP debugging
information
Enable the debugging of RIP
receiving packet.
Enable the debugging of RIP
sending packet.
As shown in Figure 4, the Switch C connects to the subnet 117.102.0.0 through
the Ethernet port. The Ethernet ports of Switch A and Switch B are connected to
the network 155.10.1.0 and 196.38.165.0, respectively. Switch C, Switch A, and
Switch B are connected by Ethernet 110.11.2.0. Correctly configure RIP to ensure
that Switch C, Switch A, and Switch B can interconnect.
Command
undo filter-policy gateway ip-prefix-name import
filter-policy {acl-number | ip-prefix ip-prefix-name }
import
undo filter-policy { acl-number | ip-prefix
ip-prefix-name } import
filter-policy { acl-number | ip-prefix ip-prefix-name }
export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ routing-protocol ]
Command
display rip
debugging rip packets
debugging rip receive
debugging rip send