Displaying And Debugging Gmrp - 3Com 7700 Configuration Manual

Hide thumbs Also See for 7700:
Table of Contents

Advertisement

By default, GMRP is disabled.
Enabling/Disabling GMRP on the Port
Perform the following configuration in Ethernet port view.
Table 4 Enabling/Disabling GMRP on the Port
GMRP should be enabled globally before being enabled on a port.
By default, GMRP is disabled on the port.
Displaying and
After the previous configuration, execute the display command to display the
Debugging GMRP
GMRP configuration, and to verify the effect of the configuration.
Execute the debugging command in user view to debug GMRP configuration.
Table 5 Display and Debug GMRP
Implement dynamic registration and update of multicast information between
Example: Configuring
GMRP
switches.
Figure 3 GMRP Networking
Switch A
Configure LS_A:
1 Enable GMRP globally.
[SW7700] gmrp
2 Enable GMRP on the port.
[SW7700] interface Ethernet 1/0/1
[SW7700-Ethernet1/0/1] gmrp
Configure LS_B:
1 Enable GMRP globally.
[SW7700] gmrp
2 Enable GMRP on the port.
[SW7700] interface Ethernet 1/0/1
Operation
Enable GMRP on the port
Disable GMRP on the port
Operation
Display GMRP statistics.
Display GMRP global status.
Enable GMRP debugging
Disable GMRP debugging
E0/1
Command
gmrp
undo gmrp
Command
display gmrp statistics [ interface interface_list ]
display gmrp status
debugging gmrp event
undo debugging gmrp event
E0/1
Switch B
GMRP
115

Advertisement

Table of Contents
loading

Table of Contents