Display And Debug Rip - 3Com 7700 Configuration Manual

Display and Debug RIP

Example: Typical RIP
Configuration
After configuring RIP, execute the display command in all views to display the RIP
configuration, and to verify the effect of the configuration. Execute the
debugging command in user view to debug the RIP module. Execute the reset
command in RIP view to reset the ssytem configuratio parameters of RIP.
Table 21 Display and Debug RIP
Operation
Display the current RIP running
state and configuration
information.
Enable the RIP debugging
information
Enable the debugging of RIP
receiving packet.
Enable the debugging of RIP
sending packet.
Restore the default RIP settings
As shown in Figure 4, the Switch C connects to the subnet 117.102.0.0 through
the Ethernet port. The Ethernet ports of Switch A and Switch B are connected to
the network 155.10.1.0 and 196.38.165.0, respectively. Switch C, Switch A, and
Switch B are connected by Ethernet 110.11.2.0. Correctly configure RIP to ensure
that Switch C, Switch A, and Switch B can interconnect.
Figure 4 RIP Configuration
Ethernet
Switch C
Network address:
117.102.0.0/16
Note: The following configuration only shows the operations related to RIP. Before
performing the following configuration, verify that the Ethernet link layer works
normally.
1 Configure RIP on Switch A:
[Switch A] rip
[Switch A-rip] network 110.11.2.0
[Switch A-rip] network 155.10.1.0
2 Configure RIP on Switch B:
[Switch B] rip
[Switch B-rip] network 196.38.165.0
Command
display rip
debugging rip packets
debugging rip receive
debugging rip send
reset
Interface address:
155.10.1.1/24
Interface address:
110.11.2.1/24
Interface address: Interface address:
196.38.165.1/24
117.102.0.1/16
Network address:
155.10.1.0/24
Switch A
Network address:
110.11.2.2/24
Switch B
Network address:
196.38.165.0/24
RIP 75