Chapter 9—Options
Transfer Mechanism
The thermal transfer mechanism is only available as a factory-installed
option. It allows the use of both direct thermal and thermal transfer sup-
plies.
Side Doors
The EasyCoder PF2i comes with either a short side door, which only
covers the print mechanism or with a long side door, which encloses the
entire media compartment. The long side door has a slot for external
media supply. The long side door is generally illustrated throughout this
manual, but pictures of the short side door can be found at the start of
this chapter and in Chapter 4.
Integral Liner Takeup Unit
The integral liner takeup unit is an optional device for peel-off (self-strip)
operation, which means the labels are separated from a liner (back-
ing paper) after printing and the liner is wound up on an internal hub.
The unit also includes a guide shaft. Peel-off cannot be combined with
Quick-Load guides, see below.
Media Supply Hub
The rotating media supply hub is designed to fi t media roll cores with
an internal diameter of 38-40 mm (1.5 inch). The hub can be fi tted in
the same positions as the supply roll post, see Chapter 2. Being factory
installed, the position of the media supply hub is not intended to be
changed by the operator.
3-inch Adapter
The 3-inch/76 mm adapter is used with a rotating media supply hub and
makes it possible to use media rolls with 3 inch/76 mm inner diameter
cores. The adapter is pressed onto the hub and secured by a screw. Not
used with a media supply roll post.
Intermec EasyCoder PF2i—User's Guide (Fingerprint version)
83