Tickets With Gap - Intermec EasyCoder PF2i User Manual

Appendix B—Media Specifi cations
Tickets with Gaps
⇐ a ⇒ Media Width
Maximum:
Minimum (standard):
Minimum (Quick-Load):
⇐ b ⇒ Copy Length
Max. length between slots: depends on SDRAM size
Min. length between slots:
Under ideal circumstances, a minimum ticket length of 4 mm (0.16
inches) could be used. It requires the sum of the copy length (b) and
the detection slit height (e) to be larger than 7 mm (0.28 inches), that
batch printing is used, and that no pull back of the media is performed.
Intermec does not guarantee that such short tickets will work, but it is up
to the user to test this in his unique application.
⇐ c ⇒ LSS Detection Position
Five fi xed positions, see Chapter 12.
⇐ d ⇒ Detection Slit Length
The length of the detection slit (excluding corner radii) must be mini-
mum 2.5 mm (0.10 inches) on either side of the LSS detection position
(e).
⇐ e ⇒ Detection Slit Height
Maximum:
Recommended:
Minimum:
Media Type Setup
• Ticket (w gaps)
Note: Do not allow any perforation to break the edge of the
media as this may cause the media to split and jam the printer.
118
60.0 mm (2.36 inches)
25.0 mm (1.00 inches)
40.0 mm (1.57 inches)
8.0 mm (0.32 inches)
21.3 mm (0.83 inches)
1.6 mm (0.06 inches)
1.2 mm (0.05 inches)
Intermec EasyCoder PF2i—User's Guide (Fingerprint version)