Media Supply Positions - Intermec EasyCoder PF2i User Manual

Media Supply Positions

There are four sets of threaded holes and slots in the printer's center sec-
tion for the media supply roll post or rotating hub (optional). These slots
allow the largest possible roll size to fi t, given the limitations of any liner
takeup and/or the full enclosure provided by the long side door. The
positions are indicated by numbers engraved in the center section.
• Position 1 is used when the media compartment is fully enclosed by a
long side door, regardless of the existence of any integral liner takeup
unit. Maximum roll size is 152 mm (6 inches).
• Position 2 is used when the printer has a short side door that only
encloses the print mechanism, but does not have an integral liner
takeup unit. Maximum roll size is 203 mm (8.00 inches).
• Position 3 is used when the printer has a short side door and an inte-
gral liner takeup unit. Maximum roll size is 213 mm (8.38 inches).
• Position 4 is not used.
The printer can also use an external media supply located behind the
printer.
Intermec EasyCoder PF2i—User's Guide (Fingerprint version)
Chapter 2—Installation
Position 3
Position 1
Position 2
Position 4
(not used)
11