Intermec EasyCoder PF2i User Manual page 59

• The length setup also decides the amount of media feed when using
"fi x length strip."
• The length setup creates an emergency stop, which works when the
printer is set up for "Label (w gaps)", "Ticket (w mark)", or "Ticket
(w gaps)." If the label stop sensor (LSS) has not detected a gap or
mark within 150% of the set length, the media feed is automatically
stopped to avoid feeding out a whole roll of media, because of an LSS
malfunction.
By setting up the X-start, the Width, and the Length, you will create a
print window inside which the printing can be performed. Any object or
fi eld extending outside the print window in any direction will either be
clipped or cause an error condition (Error 1003 "Field out of label"), see
Intermec Fingerprint v8.xx, Programmer's Reference Manual.
Print Window
Length
Origin
Dot-line
on printhead
X-start
Dot #0
Intermec EasyCoder PF2i—User's Guide (Fingerprint version)
max. 56.0 mm (2.2 in)
PRINT PRINT
WINDOW WINDOW
Width (1-448)
FEED
DIRECTION
25-60 mm (1-2.36 in)
Chapter 6—Setting Up the Printer
4 mm (0.16 in)
Dot #447
51