Peel-Off (Self-Strip) - Intermec EasyCoder PF2i User Manual

Peel-Off (Self-strip)
The EasyCoder PF2i can print on labels, tickets, tags, and continuous
stock in various forms. This section describes the case when self-adhesive
labels are separated from the liner immediately after printing. The liner
is then wound up on an integral liner takeup hub. This is also known as
"Self-strip" operation.
Peel-off operation cannot be performed when Quick-Load guides are
fi tted.
Use the <Feed> key (see fi gure #14) when loading the same type of
media. When switching to a new type of media, or if the printer does not
feed out the media properly, simultaneously press the <Shift> and <Feed>
keys to perform a "testfeeed."
Peel-off can only be used for:
• Self-adhesive labels with liner
An optional label-taken sensor can hold the printing of the next label
in a batch until the present label has been removed, see Chapter 9,
"Options."
Note: Peel-off operation sets high demands on the media in
regard of label stiffness, release characteristics of the adhesive
and liner, resistance against electrostatic charging etc., so the
labels will be dispensed properly. Consult your media supplier
or test the media to ascertain that it is suitable for your
application.
Intermec EasyCoder PF2i—User's Guide (Fingerprint version)
Chapter 4—Media Load
29