Xante Assel-a-Writer-8300 Instruction Manual page 5

Shielded cables must be used with this unit to ensure compliance with the
FCC Class A limits.
Power Information
Engine: 100 - 120 volts; 3.5 amps; 385 watts
Power Cord
The power cord is the main disconnect device. It should be plugged into an
easily accessible outlet.
For 115 Volt Configuration:
The power cord to be used with 115 Volt configuration is minimum type
SJT (SVT) 18/3, rated 250 Volts ac, 10 Amps with a maximum length of 15
feet. One terminated in an IEC 320 attachment plug. The other end is
terminated in a NEMA 5-15P plug.
For 230 Volt Configuration
The power cord to be used with 230 Volt configuration is minimum type
SJT (SVT) 18/3, rated 250 Volts ac, 10 Amps with a maximum length of 15
feet. One terminated in an IEC 320 attachment plug. The other end is
terminated as required by the country where it will be installed.
Le cable de transport d'energie que doit etre utilis'e la configuration 230
Volts est le type minimum SJT (SVT), 18/3, nominal 250 Volts ac, 10
Amps, 4.5 m long maximum. Un bout est raccorde comme exige par le pays
ou il sera utilis'e.
Das Netzkabel ist das haupfsachliche Diskonnektionsmittel, es sollte in eine
leicht erreichbare steckdos gesteckt werden.
Das Netzkabel kann mit einer 230 Volts Konfiguration verwonder werden
vom typ: Minimum VDE or HAR, 3 X 1.00 mm
maximal 4.5 m long. Ein Ende ontspriche dem Stecker IEC 320. Das andoro
Ende entspricht den Anfoderungen des entsprechenden Landes.
Power Conservation
_____________________________________________________
2
, 250 V ac, 10 Amps,
®
As an ENERGY STAR
CORPORATION has determined this product
meets the ENERGY STAR
energy efficiency. This printer enters a low-
power state after 30 minutes of inactivity. This
complies with the U.S. EPA ENERGY STAR
Program, but is not an EPA endorsement of the
product.
Partner, XANTÉ
®
guidelines for
v