Xante Assel-a-Writer-8300 Instruction Manual page 166

4. Check the current settings that printed near the crossed lines.
The factory default is x = 0, y = 0, which should cause each
line to print 1" (25.4 mm) from the edge of the page.
The coordinates are listed in units that indicate the change
from the factory default in dots per inch. When you make a
change using the slide bar, the coordinates at the bottom of the
screen display the change in the same units.
Note: If the current settings are not the factory defaults and
you must make adjustments to the coordinates, it may
be easier to reset the coordinates to the factory default
before beginning. To do this, click Reset Margins.
Then print another alignment test page (steps 1 and 2)
using the factory defaults.
5. Measure the distance from the edge of the page to the -x line.
This distance is dependent on the y coordinate.
• To move the -x line away from the edge of the page, move
the slide on the vertical slide bar up (toward the -y).
• To move the -x line toward the edge of the page, move the
slide on the vertical slide bar down (toward the +y).
6. Measure the distance from the edge of the page to the -y line.
This distance is dependent on the x coordinate.
• To move the -y line away from the edge of the page, move
the slide on the horizontal slide bar to the left (toward the -x).
• To move the -y line toward the edge of the page, move the
slide on the horizontal slide bar to the right (toward the +x).
7. Print another alignment page by clicking Print Test; then OK
in the Alignment message box.
8. Measure the -x and -y lines on the new test page. If the lines
are not each 1" (25.4 mm) from the edge of the paper, go back
to step 4 and repeat the process.
9. When the -x and -y lines are set correctly, click Close. Then,
select Exit from the File menu to exit Command Center.
4-50 PC Setupbb __________________________________________