Xante Assel-a-Writer-8300 Instruction Manual page 146

The Initdisk.ps files are used to initialize hard disks attached to or
installed in your printer.
• The numbered files initialize the SCSI disk with the same device
number (Initdsk1.ps intializes SCSI disk #1, Initdsk2.ps
initializes SCSI disk #2, etc.) on the printer.
• The Initdska.ps and Initdskb.ps files initialize the internal IDE
drive of the same designation (the A or B disk) on the printer.
• The Initdsks.ps file initializes all SCSI and IDE drives attached
to the printer.
Initializing a disk erases all information stored on the disk. See
"Initializing a Hard Disk" in chapter 2.
The Novell34.ps file prints instructions for setting up a XANTÉ
printer on a Novell network.
The Parmdump.ps file prints a list of the settings for the
communication devices currently configured for your printer. If you
call XANTÉ Technical Support, you may be asked to print this page
to check your setup.
The Setzone.ps file allows you to set the EtherTalk zone name for
the printer. Open the file in a text editor and change "name of zone"
in the parentheses to the name of your EtherTalk zone. Save the file,
and download it to your printer. The printer must be restarted before
the change is effective.
The Set_IP.ps file allows you to set the IP address for your printer.
Open the file in a text editor and change the IP address in the
parentheses to the IP address of your printer. Save the file, and
download it to your printer. The printer must be restarted before the
change is effective.
The Startpg.off file disables the printer's start-up page feature,
which prevents it from printing automatically each time the printer is
restarted (see "Startup Page Menu" in chapter 5).
4-30 PC Setupbb __________________________________________