Procedures; The Spooler; Using The Front Panel; Using Xanté Command Center - Xante Assel-a-Writer-8300 Instruction Manual

Procedures

This section contains instructions for performing common
procedures using the programs provided in the XANTÉ Utilities.

The Spooler

Spooling can be enabled for each interface independently through
XANTÉ Command Center or the Interface menus on the printer's
front panel. XANTÉ Command Center also allows you to manage
the jobs in the spooler print queue. See chapter 8, "Advanced
Features," for additional information.

Using the Front Panel

The Spooler can be enabled using the Spooler menu of the interface
that you will be using (see chapter 5, "Configuration," for additional
information).
1. Select the Interface (SETUP:INTERFACES) menu.
2. Select the printer interface (SERIAL, PARALLEL,
ETHERTALK, LPR, or NOVELL PSERVER) that you use to
send files.
3. Select the Spool menu.
4. Select the YES option.
5. Press the On Line key to return the printer to the
READY/IDLE state.
Using XANTÉ Command Center
This option allows you to enable and control spooling on the
printer's hard drive.
To Enable the Spooler
1. Open XANTÉ Command Center and select Spooler from the
Controller menu to open the Spooler window.
___________________________________________ PC Setup 4-39