Printing On Custom Sized Media - Xante Assel-a-Writer-8300 Instruction Manual

• Do not use label sheets with exposed adhesives (such as partially
used sheets or sheets on which the adhesive has seeped through
to the surface).
• Do not use thick, rough, textured, coated, synthetically
reinforced, curled, torn, or otherwise damaged label stock.
• Format your labels in your application and run a test print on
plain paper to check alignment before running on the more
expensive label stock.

Printing on Custom Sized Media

The Adobe PostScript printer drivers supplied with the XANTÉ
Utilities disks allow you to print on media from 3.90" x 5.80" (99
mm x 147 mm) up to 12.00" x 25.00" (305 mm x 635 mm). Oversize
printing allows you to print 11" x 17"/A3 (279 mm x 432 mm) full
size bleeds.
Set the custom page size through your application. Be sure that the
paper size selections in the page or document setup section agree
with those in the Print dialog box to ensure that the page prints
correctly.
If the extra wide print option is installed, the imageable area for
12.00" (305 mm) wide media is increased (see "Media Sizes" earlier
in this chapter). Be sure to set the page margins in your applications
to fit within the imageable areas.
Use only media that meets the guidelines listed in "Media
Specifications" earlier in this chapter. Always feed custom sized
media from the manual feed tray following the instructions in
"Feeding Media to the Printer" earlier in this chapter and "The
Manual Feed Tray" in chapter 2.
________________________________ Using Media and Toner 7-13