Select Message Length - Newland HR200 User Manual

Symbols
Matrix 2 of 5

Select Message Length

It is used to program the valid reading length of Matrix 2 of 5. The engine
will not send barcode message to the Host, if the decoded data length does not
match the valid length.
Matrix 2 of 5 Message Length is defined by "Min. Message Length" and
"Max. Message Length"
Min Message Length (default: 4)
【Pro CMD：0406030】
1D bar code Message Length should not exceed 127 bytes. If Max Message Length is
less than Min Message Length, it means the engine will only support barcodes of the two
lengths. If Max Message Length is equal to Min Message Length, the engine will only sup-
port barcodes of the length.
To set Min Message Length of Matrix 2 of 5 as 8 bytes, and Max Message length as 12
bytes, read these programming codes:
1. "Code Programming ON"
2. "Select Min Message Length"
3. Digit Code "8", see Digit Code Appendix (Pxxx)
4. "Save Programming", see Digit Code Appendix (Pxxx)
5. "Select Max Message Length"
6. Digit Code "1"
7. Digit Code "2"
8. "Save Programming"
9. "Code Programming OFF"
nlscan.com
MaxMessage Length (default: 80)
【Pro CMD：0406040】
Tools
Code Programming ON
Code Programming OFF
Page 74