How To Build A Batch Command - Newland HR200 User Manual

Batch Programming

How to build a batch command

Batch command can contain many commands. Each command is divided by semicolon. Batch command
must be ended with save command.
Command structure: command (+ equal mark + setting information)
The setting command list is provided below
There are 4 setting command modes
1. Setting syntax 1: Command
The most command is the one can be set at one time without the command.
e.g.:
The command setting the baud rate as 38400 bps: 0100060
The command setting auto mode: 0302010
2. Setting syntax 2: Command + equal mark + number
This command is used for setting the value of parameter, including the longest and shortest length of the
barcode, one reading timeout setting, same barcode reading delay setting, sensitive value setting, etc.
e.g.:
The command setting the one reading timeout as 3000ms: 0313000 = 3000
The command setting the sensitive value as 10: 0312040 = 10
3. Setting syntax 3: command + equal mark + hex (e.g., 0x101a，0x2C03)
This command can be used as setting the user-defined prefix, user-defined suffix, ending suffix, CodeID,
increase or cancel the barcode length value, information intercepting, etc. Note: every two hexes in the
command stand for a setting character
e.g.:
Append the fixed length 4 of interleaved 2of 5 to 26: 0405160 = 0x041a
Setting the suffix information of the ending as CR/LF: 0310000 = 0x0d0a
4. Setting syntax 4: command + equal mark+ double quotation marks
If the setting information is viewable character, then this mode of setting is appropriate.
e.g.:
The command setting the user-defined prefix information as AUTO-ID ： 0300000 = "AUTO-ID"
nlscan.com
Page 142